Seth Muhammad Tufail and Sons

Water Pump

×

SETH TUFAIL WATER PUMP ST-I

Seth Tufail "Water Pump" is a pump designed for pumping water from wells with water level. The pump cylinder is near the well water level and the water is forced to the surface rather than being sucked to it. Our water pump is known for its best performance, best quality and long service life.

A deep-well pump drives underground water to its hub and delivers the water to water storage tank the specific pressure according to the specification of the pump.

Seth Tufail Pumps delivers outstanding water pressure. It’s made by giving a close attention to each and every detail which makes it the best. Seth Tufail Pumps are made with hi-tech modern machinery so that quality is never compromised. All the materials used in the pump are tested and are fitted with a passion. It comes with the best materials like the bearing, Japanese imported seal which guarantees of not even leaking a single drop of water from the pump. The SS grade impellers gives you the long-lasting pump experience without any hassle. 99% Pure copper wire used so the power of the AC motor isn’t compromised. The Pump comes with a 3 months Motor Warranty and a full 1 year pump warranty.

image

Installation

  • Make sure the pump body in top-on with water before turfing it on.
  • Pump should be leveled and in horizontal position in any circumstance.
  • Make sure the pipes are fully connected with the pump and injector.

Features

Our Water Pump is known for its performance and quality.

  • Seth Tufail pumps (95769) runs soundproof while delivering the best quality
  • Delivers the best performance regarding its water pressure and water flow.
  • Beautiful designed by keeping an eye on the modern culture.

Technical Specification of Water Pump ST-I

PARTICULARS

MOTOR 0.75 HP (Single Phase)
MATERIAL Cast-Iron
AMPERES 4
FLOW 37 L/m
SUCTION 80 Ft
HEAD 80 Ft
RPM 2850
CAPACITOR 25 uf
VOLTS 200 ~ 230v
BEARING 6203zz
FREQUENCY 50Hz
×

SETH TUFAIL WATER PUMP ST-II

A deep-well pump drives underground water to its hub and delivers the water to water storage tank the specific pressure according to the specification of the pump.

Seth Tufail Pumps delivers outstanding water pressure. It’s made by giving a close attention to each and every detail which makes it the best. Seth Tufail Pumps are made with hi-tech modern machinery so that quality is never compromised. All the materials used in the pump are tested and are fitted with a passion. It comes with the best materials like the bearing, Japanese imported seal which guarantees of not even leaking a single drop of water from the pump. The SS grade impellers gives you the long-lasting pump experience without any hassle. 99% Pure copper wire used so the power of the AC motor isn’t compromised. The Pump comes with a 3 months Motor Warranty and a full 1 year pump warranty.

image

Technical Specification of Water Pump ST-II

PARTICULARS

MOTOR 1.5 HP (Single Phase)
MATERIAL Cast-Iron
AMPERES 6.5
FLOW 37 L/m
SUCTION 130 Ft
HEAD 130 Ft
RPM 2900
CAPACITOR 30 uf
VOLTS 200 ~ 230v
BEARING 6203zz
FREQUENCY 50Hz

What parts do you use to assemble a pump?

  • Stainless steel impeller
  • Japanese imported ceramic mechanical seal
  • World's top-notch quality ball bearings
  • Made by high quality cost iron
  • 99% original high quality copper wire
  • Fan-cooled 0.5 HP Motor
  • High-Quality 20 μf capacitor

What causes water pressure?

Pressure and flow are inversely related–that is, if pressure is increased, then flow decreases, and vice versa. "Pressure" is the amount of force per area, and "flow" is the volume of material moving through a given area per second (not the same as velocity, which is the distance traveled per time). Water pressure is caused by resistance to flow. If a force tries to move water and there is resistance to that movement, then the water becomes pressurized. Consider a standard garden hose; when the end of the hose is unrestricted, water flows out of the hose in large quantities, but without much force. If you press your thumb over the opening, however, the stream of water that shoots out from around your thumb will be much more forceful and will travel further, but there will also be less water per second leaving the hose.

What is your Water Pump quality?

We have more than half a century experience in manufacturing agricultural equipment, we are making the best and high quality Water Pump. We check every Water Pump very closely before shipping.

Is my water pump supposed to leak water from around the shaft seal?

Yes. A small amount of water leaking through the shaft seal is necessary to lubricate and cool the rope packing and shaft sleeve. The recommended leakage rate is between 60 and 120 drops per minute, which will result in a small trickle of water. If water leakage is excessive, simply adjust the packing glands to compress the rope packing until leakage is within the recommended parameters.

Can Seth Tufail water pumps be damaged by freezing?

Yes. If a pump is allowed to freeze with water in it, cracking of the volute case as well as damage to the shaft and bearings may occur. Thoroughly drain the water from your pump and tank in freezing weather. If the pump has been frozen, disassemble and inspect it for damage before returning it to service.

Do you offer guarantee?

Yes, we offer guarantee.

From where I can buy Seth Tufail's Water Pump?

You can buy it from our any authorized distributor. Our distributors are in almost every city of Pakistan including Kashmir.

Is it okay to run the pump dry?

The water pump shaft and impeller are rotating at high RPMs. Without water to transfer the heat created by rotational energy, the moving parts become extremely hot, causing severe damage to the pump and significantly limiting service life.

Can we operate it with solar energy?

Yes, you can operate our Water Pump with solar energy but it requires some additional convertor. Consult your solar system installer before connecting it or call us for more details.

What about the spare parts? In case I need it, from where I can buy?

We are keeping manufacturing all parts of our all Water Pump models. Our quality of spare parts are easily available from our distributors.

How much water pressure should Seth Tufail water pump develop?

Water pressure should be checked with water in the tank, spray heads closed, and the tractor engine at high idle. To obtain acceptable spray performance, a minimum of 85 psi water pressure under static conditions (no water flowing) is required. A static water pressure exceeding 125 psi can cause damage to water lines, connections and spray heads. Please contact us for assistance.

Do you offer after sales services?

Yes, our dedicated support team is always there to help you. For more details,CALL US